|
|
GPS
OFF-LINE MONITORING PRODUCTS - Hardware
|
|
GuardMagic
mTF2
Advanced "GPS
& Fuel Data Logger" with additional inputs,
driver identification function and USB output interface.
|
ABOUT mTF2
GuardMagic mTF2 is advanced multifunction "GPS & Fuel Data Logger" with
additional inputs, driver identification function and USB output interface for
standard USB Flash Drive connection..
GuardMagic
mTF2 carry out the fuel usage control (fuel consumption, fueling and fuel
draining) and allow to control up to two fuel tanks.
GuardMagic mTF2 is designed for the automatic recording information of
vehicle trip (GPS track), traffic parameters, fuel level in fuel tanks and
information from additional external sensors.
GuardMagic mTF2 in additional has the immobilizer function to prevent not
authorized use of transport (and can carry out the guard function).
GuardMagic mTF2 is intended for the construction of transportation
monitoring systems and control of fuel consumption.
GuardMagic mTF2 typical features:
-
transfer data to
a personal computer by standard USB Flash Drive (USB stick);
-
240 thousand
records;
-
connection up to
TWO analog fuel level sensors (GuardMagic FLPa);
-
"resolution" on
"fuel inputs" - 1024 levels;
-
driver
identification function;
-
immobiliser
function;
-
two main
operation mode:
- transport,
- special technics.
-
automatically
switch to "sleep mode" (energy-efficient mode) if transport with no activity;
-
connection up to
three additional user logic sensor.
GuardMagic
mTF2 module can be installed at:
-
vehicles
(passenger and freight);
-
road construction
or a special technique;
-
agricultural
technology;
-
tractors,
bulldozers, excavators, harvesters, etc.;
-
railway
locomotives.
GuardMagic
mTF2 provides a record in internal non-volatile memory the following
information:
-
trip of vehicle
(GPS track; geographic coordinates);
-
traffic
parameters (speed, time);
-
fuel level in
fuel tanks (up to TWO tanks);
-
status of
ignition circuit (engine On-Off);
-
active driver
identification code (driver ID code);
-
fact of engine
overheat;
-
event button
pressing;
-
condition of
external logic sensors (up to THREE sensors);
-
terms of engine
starting;
-
status of GPS
receiver;
-
Information about
Engine RPM;
-
Information from
odometer circuit (for control vehicle movement without GPS coverage; for
example, in tunnel);
-
status of main
power supply.
Information
recorded (saved) in GuardMagic mTF2 later transferred to a personal computer,
where they carried out a full analysis of this information using special
software (SmartTracer or
TrackManager series).
Using the
information saved in GuardMagic mTF2 about the vehicle activity it is
possible to:
-
check the whole
track of the transport movement and the optimality of route;
-
check parameters
of movement and real run of transport;
-
check real fuel
consumption;
-
check up volume
of fueled fuel and determine the fact of fuel drain;
-
personalize the
active driver;
-
determine
start/end of loading/unloading of a vehicle;
-
check the use of
working hours;
-
check the visited
points;
-
check the
performance of the job or analyze the reason of job failure
|
|
|
